Again, all team members were present at this meeting.
We built the remaining parts for the machine, and then built a representation of the machine on Solidworks.
 |
| Part to connect the Servo Motor to the Bubble Wand |
 |
| Propeller to cause the fan, which will be attached to the DC Motor |
 |
| Stand to raise the DC Motor. Will be attached to the DC Bracket |
 |
| Dish to hold the bubble solution. Will be placed in a hole in the base of the machine. |
 |
| Base, which all parts of the machine will be mounted to. The arduino board will be underneath the base, and the wires will be fed through the small holes in the base. |
Below is the model of what the machine should look like when it is done.
No comments:
Post a Comment